Adjusting the Crop Mark of Hold Job

This section describes the Register Crop Mark function to be specified on the Job Ticket Edit screen.

Use this function to print the lines indicating the trim size (corner crop marks) along with image data stored in a hold job. Also, lines indicating the center of the image (center crop marks) can be printed on the head and foot of the page.

 

  • The crop mark can be printed with image data stored in a hold job of copy job or print job. Setting for a scan job is unavailable.

  • You can make the setting to eliminate the corner crop mark.

  • The following three types of the corner crop mark are provided to allow a selection. The line width is approximately 0.1 mm.

Type 1

Type 2

Type 3

  • For Print Object setting, select either Comp. Unit or Image Unit.

Composition Unit

Image Unit

  • The trim margin indicated by the corner crop mark can be specified from 0.1 mm to 20 mm. The default setting is 3 mm.

  • The size of the corner crop mark is 9 mm in each projection. Changing this size is unavailable.

  • You can make the setting to eliminate the center crop mark.

  • The type of the center crop mark is a cross shape only. The line width is approximately 0.1 mm.

  • The print position of the center crop mark can be specified on the UTILITY screen. For details, refer to User Setting: Common Setting.

  • The size of the center crop mark is 8.5 mm in length and 25 mm in width. Changing this size is unavailable.

  • The print position of the corner crop mark and center crop mark can be offset within the range from -20 mm (inward) to +20 mm (outward) in 0.1 mm increments for both X-coordinate and Y-coordinate. The default setting is 0.0 mm.

  • Select whether to print the corner crop mark and center crop mark on the back in 2-sided printing.

  • Specify whether or not to synchronize the print position of the corner crop mark and center crop mark with Page Margin.